Publicité
For Aermotor Thermax Units Only
Installation of Drop Pipe
into Discharge Head
DROP PIPE
HAND TIGHTEN 4% TO 5 FULL TURNS, THEN
TIGHTEN WITH WRENCH ሄ TURN.
BEFORE INSTALLATION OF DROP PIPE AND HEX
BUSHINGS (If used) WRAP THREADS WITH
፡!!!
ОМ ТАРЕ OR APPLY THREAD SEALANT USING
AMOUNT SUFFICIENT TO ASSURE A PRESSURE
TIGHT SEAL WHEN TIGHTENED.
DO NOT OVER TIGHTEN PAST THE INTERNAL
PIPE STOP.
DURING INSTALLATION OF DROP PIPE, APPLY
WRENCH TO DISCHARGE HEAD SURFACE AS
SHOWN.
DISCHARGE HEAD
Page 5
Publicité
