Publicité
Section 2
Connect to L1 & L2 of
Contactor
5. To allow access for LuminIce™ tubing, the plastic
caps in the bulkhead wall must be removed and
discarded.The cap located behind the evaporator
will fall into the water trough. Remove water trough
to retrieve, then discard cap and reinstall the water
trough.
Part Number 000008463 Rev01 4/15
6. Assemble bracket, hoses and wires to LuminIce™
module.
•
Short hose will route to access hole behind the
evaporator. Attach 90 degree elbow to one end and
attach other end to LuminIce™.
•
Long hose will route to the access hole above the
float switches. Attach 90 degree elbow to one end
and attach other end to LuminIce™
•
Route low voltage wiring (black and yellow wires) to
the LuminIce™ module and snap wire harness
connectors together.
•
Attach both hoses to the bulkhead by pressing in
place.
Installation Instructions
13
Publicité
