Publicité
OPEN-CLOSE-INVERT or OPEN-STOP-CLOSE-STOP with button (contact 2-7)
By default, the feature is OPEN-CLOSE-INVERT.
To enable it to OPEN-STOP-CLOSE-STOP:
select
the
DIP-switches
control
board.
The
To return to the default setting, press PROG again The LED blinks and the buzzer sounds off 2 times
Partial opening or pedestrian opening (contact 2-3P)
By default, the opening is set to pedestrian mode.
To enable in partial opening:
select
the
DIP-switches
control
board.
The
To return to the default setting, press PROG again The LED blinks and the buzzer sounds off 2 times
Obstruction detection with motor stopped
By default, this function is enabled.
To disable it:
select the DIP-switches as shown and press the PROG button on the control board. The LED blinks and the
buzzer sounds off 2 times.
To return to the default setting, press PROG again. The LED stays on and the buzzer sounds off for 1
second.
Excluding the Encoder
By default, the Encoder is enabled.
The enable the exclusion:
select the DIP-switches as shown and press the PROG button on the control board. The LED blinks and the
buzzer sounds of 1 time.
To return to the default setting, press PROG again. The LED stays lit and the buzzer sounds off 2 times.
Timed slow-downs (with Encoder disabled)
By default, the feature is disabled.
To enable it:
select the DIP-switches as shown and press the PROG button on the control board. The LED stays on and
the buzzer sounds off for 1 second.
To return to the default setting, press PROG again. The LED blinks and the buzzer sounds off 2 times.
Set the OP TIME trimmer to its maximum setting, the SENS trimmer to half, and save the trimmer value.
Automatic closing
By default, the feature is disabled.
To enable it:
select the DIP-switches as shown and press the PROG button on the control board. The LED stays on and
the buzzer sounds off for 1 second.
To return to the default setting, press PROG again. The LED blinks and the buzzer sounds off 2 times.
The wait before the automatic closing starts when the opening limit-switch point is reached - for a time that
is settable on the A.C.T. trimmer.
⚠ The automatic closing does not activate if the safety devices are triggered due to obstacle detection,
after a total stop or if the power supply is missing.
Automatic closing after either partial or pedestrian opening
By default, the feature is disabled.
To enable it:
Select the DIP-switches as shown and press the PROG key on the control board. THE PRG LED stays lit and
the buzzer sounds off for 1 second.
To return to the default setting, press the PROG key again. The LED blinks and the buzzer sounds off 2
times.
⚠ The automatic closing time is permanently set to 10 seconds.
as
shown
and
LED
stays
on
and
as
shown
and
LED
stays
on
and
press
the
PROG
the
buzzer
sounds
press
the
PROG
the
buzzer
sounds
key
on
the
for
1
second.
key
on
the
for
1
second.
Publicité
