Publicité
5
Use
5.1.1
Switching on
The BoomBoom 100 does not start connecting to your devices
if these are already switched on. Therefore, it is advisable to
switch on the BoomBoom 100 first, followed by the previously
connected devices.
5.1.2
Re-pairing
Previously paired Bluetooth devices connect automatically
with the BoomBoom 100 when switched on.
5.1.3
Adjusting the volume
The BoomBoom 100 is a passive transmitter or receiver and
does not have volume settings. The desired volume level must
be set on the devices that are paired with the BoomBoom 100.
5.1.4
Removing paired devices
To remove previously paired devices from memory, please
follow these steps:
Ensure that the BoomBoom 100 is switched on in RX or TX
mode.
Slide the multifunctional switch (2) all the way to the right (BT)
for 6 seconds.
The LED will first flash red/blue and then turns red/blue
constantly.
If the LED then starts to flash red/blue again, you can slide the
multifunctional switch back to the centre position for the
optical connection (OPT), or completely to the left for the
analogue connection (AUX).
The BoomBoom 100 is now in pairing mode and all previously
paired devices have been deleted from its memory.
Continue with point 4.2.3 or point 4.3 to pair your Bluetooth
device.
6
Product details
6.1
Technical specifications
Bluetooth
12
© MARMITEK
Publicité
