Publicité
24 electrolux
When you connect the appliance to the elec-
trical supply or in case of a power cut, the
Time function indicator flashes automatically.
To set the current time use " + " or " - " but-
ton.
After approximately 5 seconds, the flashing
stops and the display shows the time of day
set.
For time change you must not set an au-
tomatic function (Duration
) at the same time.
Hob - Daily Use
Ignition of the burner
Warning! Be very careful when you use
open fire in kitchen environment.
Manufacturer decline any responsibility
in case misuse of the flame
Always light the burner before you put
cookware.
To light the burner:
1. Push and hold the spark generator but-
ton
.
2. Turn the control knob counterclockwise
to the maximum position
3. Release the spark generator button but
keep the control knob on this position for
approximately 5 seconds; this will let
thermocouple to warm up. If not, the gas
supply will be interrupted.
4. Adjust the flame after it is regular.
If after some tries the burner does not
light, check if the crown and its cap are
in correct positions.
Initial Cleaning
• Remove all parts from the appliance.
• Clean the appliance before first use.
Preheating
Set
an empty oven for 45 minutes, to burn off any
residue from the cavity surface. Accessories
can become hotter than in normal use. Dur-
ing this period an odour can be emitted. This
is normal. Make sure the room is well venti-
lated.
or End
.
1
Burner cap
2
Burner crown
3
Ignition candle
4
Thermocouple
Caution! Do not use abrasive cleaning
agents! This can damage the surface.
Refer to chapter "Care and Cleaning".
and maximum temperature and run
Warning! If the burner does not light
after 15 seconds, release the control
knob, turn it into off position and try to
light the burner again after minimum 1
minute.
1
2
3
4
Publicité
