Publicité
Manual_FX-MS152T_Int24_Rev5
REFILLING TRIMMING LINE
1. For replacement line, use a diameter of 2.4mm
(.095in). The spool is capable for a line up to 6m
(20ft) on the 10cm (4") head. Avoid using a larger
line as it may cut down the trimming performance.
2. Pinch the slotted area on the both sides of the
spool housing to unhook the bottom cap.
3. Take out the spool and pull off the old line. Put
one end of new line through the spool holes and pull
it until the length is equal between each part of the
line.
4. Wind up the line in the correct direction as
indicated on the spool.
5. Hook each end of the line in the slot on the edge
of the spool, and then put the ends through the
eyelets on the housing. Make sure that the spring
and the washers are in place.
6. While holding the spool against the housing, pull
the line ends to release them from the slot.
7. Line up the slot on the bottom cap with the hook
on the housing, press the cap against the housing
until it clicks.
AIR FILTER
The air filter, if clogged, will reduce the engine
performance. Monthly check and clean the filter
element in warm, soapy water as required. Dry
completely before installing. If the element is
broken or shrunk, replace with a new one.
FUEL FILTER
•
When the engine runs short of fuel supply, check the fuel cap
and the fuel filter for blockage.
(1) Fuel filter
52
Publicité
