Publicité
Manual_FX-MS152T_Int24_Rev5
28. Operation
STARTING ENGINE
WARNING
The cutting head will start rotating upon the engine starts.
1. Feed fuel into the fuel tank and tighten the cap securely.
2. Rest the unit on a flat, firm place. Keep the cutting head off the
ground and clear of surrounding objects as it will start rotating
upon starting of the engine.
3. Push the primer pump several times until overflown fuel flows
out in the return tube.
4. Move the choke lever to the closed position.
(1) Choke lever
(2) Closed position
(3) Open position
5. Set the ignition switch to the "start" position.
1. throttle lever
2. throttle trigger
3. Stop switch
O: Stop position
I: Start position
6. While holding the unit firmly, pull out the starter rope quickly
until engine fires.
IMPORTANT
•
Avoid pulling the rope to its end or returning it by releasing
the knob. Such actions can cause starter failures.
7. Move the choke lever to the open position. And pull out the starter rope quickly to restart engine.
8. Allow the engine to warm up for several minutes before starting operation.
NOTE
1. When restarting the engine immediately after stopping it, leave the choke open.
47
Publicité
