Publicité
OTHER FEATURES
Reset Filter
The red LED indicator will light every 6 months as a
reminder to replace the charcoal filter .
After replacing the charcoal filters, Hold the FILTER
button for 3 seconds to turn off the Red LED indicator.
Charcoal Filter
The charcoal filter cannot be cleaned. It must be
replaced. Order Part No. WB02X11550 from your
Haier supplier.
If the model is not vented to the outside, the air will be
recirculated through a disposable charcoal filter that
helps remove smoke and odors .
The charcoal filter should be replaced when the red LED
indicator lights under the FILTER pad .
To Remove The Charcoal Filter
To remove the charcoal filter, first disconnect power at
the main fuse or circuit breaker, or pull the plug . Open
the microwave oven door and push the "Push" area on
charcoal filter cover at center of the grille. Press back
on the top of the filter with both hands until the filter lays
down almost horizontal. Lift the filter at the bottom until it
comes free of the tabs . Slide the filter down and out .
29-6379
Filter
Hold 3 Sec
To Install The Charcoal Filter
To install a new charcoal filter, remove plastic and
other outer wrapping from the new filter .
Insert the top of the filter up and into the grooves on both
sides of the inside of the top opening . Once you have
cleared the bottom tab, push the bottom of the filter in
until it rests in place vertically behind the tab .
Close the charcoal filter cover at center of the grille by
pushing the "Push" area again.
Grooves in
Microwave for
Filter on Each
Side
Filter (dashed to show
details of grooves)
Bottom Tab
19
Publicité
