Publicité
B2
USE TOP CABINET TEMPLATE FOR
PREPARATION OF TOP CABINET
You need to drill holes for the top support screws, a
hole large enough for the power cord to fit through, and
a cutout large enough for the exhaust adaptor .
• Read the instructions on the TOP CABINET
TEMPLATE.
• Tape it underneath the top cabinet .
• Drill the holes, following the instructions on the TOP
CABINET TEMPLATE.
Wear safety goggles when drilling
CAUTION
holes in the cabinet bottom.
B3
CHECK BLOWER MOTOR
ORIENTATION
The blower fan blade opening should be facing the top
of the microwave . If the fan opening is already facing
the top of the microwave, skip to Step B5. Otherwise,
continue to Step B4 to adjust the blower orientation.
B4
ADAPTING BLOWER FOR OUTSIDE
VENTILATION
Under the condition of the blower cover is installed
1
on the top of the microwave, remove the screw
holding the blower cover and remove the blower
cover from the blower plate by sliding it right .
Blower
Cover
Screw
1" = 2.5 cm; 1' = 0.3 m
29-6379
Installation Instructions
Blower
Cover
B4
ADAPTING BLOWER FOR OUTSIDE
VENTILATION
Remove the 3 screws securing the blower plate,
2
and remove the blower plate from the outer case
by sliding it toward the back of the microwave and
pulling up .
Blower Plate Screws
Blower Plate
Carefully pull out the blower unit . The wires will
3
extend far enough to allow you to adjust the blower
unit .
Rotate 90°
Roll the blower so that the fan blade openings are
4
facing the top of the oven. Place the blower back
into the opening .
Fan Blades
Wires
NOTE: Make sure the wires remain routed through the
openings in the motor frame . To avoid damage to the
fan motor wiring, insert motor carefully such that the
fan motor wiring does not contact the microwave power
cord bracket .
WARNING
Risk of Electric Shock.
Can cause injury or death. Do not pull or stretch
the blower unit wiring. Make sure the wires are not
pinched.
Back of
Microwave
Back of
Microwave
45
Publicité
