Publicité
D
MARKING THE MOUNTING HOLES
OPTION 2: USE METAL BRACKET AS TEMPLATE
NOTE: Refer to step C "DETERMINING MOUNTING PLATE LOCATION UNDER YOUR CABINET on page 36 for
aligning instructions .
STEP 1: Draw a vertical line on the wall at the center of
the 30" space.
STEP 2: Installer uses bracket to make 2 marks . First
mark is made by using the stampled slot in bracket .
Second mark is made on the ouside edge of bracket .
Make a mark
here on the
outside edge
of the bracket
STEP 3: Installer moves bracket to the other side of the
cabinets and makes 2 more marks . Marks are the same
as STEP 1, just opposite side.
Make a mark here, along
inside bottom of the stamped
slot provided (same as Step 1) .
1" = 2.5 cm; 1' = 0.3 m
38
Installation Instructions
Make a mark here, along
inside bottom of the stamped
slot provided .
Make a mark
here on the
outside edge
of the bracket
STEP 4: Installer uses a level to draw a horizontal line
that connects the two marks made with the stamped slot
in the bracket .
Horizontal line
STEP 5: Installer places the mounting bracket on the
wall as shown in the picture . Draw circles on the wall
at holes A and B. Draw one circle in areas C and D. At
least one of the C or D circles MUST line up with a wall
stud .
Mark hole locations for
A, B, C, and D.
B
D
Place bracket within the lines created in previous steps.
STEP 6: Set mounting bracket aside and drill holes at all
marked locations. If there is a stud, drill a 3/16" hole for
wood screws . For holes that do not line up with a stud,
drill a 5/8" hole for a toggle bolt.
C
A
29-6379
Publicité
