Publicité
1
PLACEMENT OF THE MOUNTING PLATE
A
REMOVING THE OVEN FROM THE
CARTON/REMOVING THE MOUNTING
PLATE
Remove the turntable, installation instructions,
1
filters, exhaust adaptor, damper, shelf and the
small hardware bag . Do not remove the foam
packing protecting the front of the oven .
Fold back all 4 carton flaps fully against carton
2
sides . Then carefully roll the oven and carton over
onto the top side . The oven should be resting in
the foam packing .
Foam
packing
Pull the carton up and off the oven.
3
The mounting plate is attached to the back of
4
the oven . Remove the two screws holding it to
the oven . The plate will be used as the rear wall
template and for mounting the oven to the wall .
Set the oven upright . Remove and properly discard
5
plastic bags and foam packing .
1" = 2.5 cm; 1' = 0.3 m
29-6379
Installation Instructions
Carton
B
FINDING THE WALL STUDS
Wall Studs
Center
Find the studs, using one of the following methods:
1
A . Stud finder – a magnetic device which locates
nails .
B. Use a hammer to tap lightly across the
mounting surface to find a solid sound .
This will indicate a stud location .
After locating the stud(s), find the center by probing
2
the wall with a small nail to find the edges of the
stud . Then place a mark halfway between the
edges . The center of any adjacent studs should be
16" or 24" from this mark.
Draw a line down the center of the studs .
3
THE OVEN MUST BE CONNECTED TO AT LEAST
ONE WALL STUD.
OR
35
Publicité
