Publicité
C3
USE TOP CABINET TEMPLATE FOR
PREPARATION OF TOP CABINET
You need to drill holes for the top support screws and a
hole large enough for the power cord to fit through .
• Read the instructions on the TOP CABINET
TEMPLATE.
• Tape it underneath the top cabinet .
• Drill the holes, following the instructions on the TOP
CABINET TEMPLATE.
CAUTION
Wear safety goggles when drilling
holes in the cabinet bottom.
C4
ADAPTING BLOWER FOR OUTSIDE
BACK EXHAUST
Remove the screw holding the blower cover and
1
remove the blower cover from the back plate of
microwave by sliding it up .
1" = 2.5 cm; 1' = 0.3 m
29-6379
Installation Instructions
Blower Cover
Blower Cover
Screw
C4
ADAPTING BLOWER FOR OUTSIDE
BACK EXHAUST (cont.)
Remove the screws securing the blower plate and
2
then remove the blower plate from the outer case
by sliding it toward the back of the microwave and
pulling up .
Blower Plate Screws
Blower Plate
Carefully pull out the blower unit . The wires will
3
extend far enough to allow you to adjust the blower
unit .
BEFORE: Fan Blade
Openings Facing Up
End A
Locate the two "knockout" plates, on the rear oven
4
panel, near the top of the oven . Using tin snips,
carefully cut the web area from the two holes side-
by-side (that secure the knockouts to the oven) .
Cut all four webs on both rear knockouts; this will
allow the ventilation fan airflow to exhaust out the
rear of the oven .
CAUTION
Be sure to trim the sharp edges from
the openings after removing the knockout plates .
Back of microwave
End B
Knockout Plates:
Snip all 4 webs on
each knockout panel
and remove the metal
knockouts for rear airflow .
Please take care to
remove any sharp edges
created from removin
49
Publicité
