Publicité
C
DETERMINING MOUNTING PLATE LOCATION UNDER YOUR CABINET
Plate Position – beneath flat bottom cabinet
Draw a vertical line on the wall at the center of the 30"
wide space . Tape the Rear Wall Template onto the wall
matching the centerline and touching the bottom of the
cabinet
Plate Position – beneath recessed bottom
cabinet with front overhang.
Draw a line on the
back wall equal to
the depth of the front
overhang
1" = 2.5 cm; 1' = 0.3 m
36
Installation Instructions
16-1/2"
30" to Cooktop
Plate Position – recessed cabinet bottom
Draw a vertical line on the wall at the center of the 30"
space .
Tape the Rear Wall Template onto the wall matching the
centerline and touching the bottom cabinet frame .
Your cabinets may have decorative trim that interferes
with the microwave installation . Remove the decorative
trim to install the microwave properly and to make it level .
THE MICROWAVE OVEN MUST BE LEVEL.
Use a level to make sure the cabinet bottom is level . If
the cabinets have a front overhang only, with no back
or side frame, install the mounting plate down the same
distance as the front overhang depth . This will keep the
microwave level .
Measure the inside depth of the front overhang .
1
Draw a horizontal line on the back wall an equal
2
distance below the cabinet bottom as the inside
depth of the front overhang .
For this type of installation with front overhang only,
3
align the Rearwall Template with this horizontal line,
not touching the cabinet bottom as described in
Step D .
30" to Cooktop
29-6379
Publicité
