Publicité
3
5
On the centre section
The U-bolts (3) must be vertical in relation
3
4
to the frame (4).
- The cone on the washer (5) must face
upwards.
- Secure the U-bolt (3) using a washer
(5) and a nut.
- Tighten the nuts alternately and evenly
to 220 Nm.
If the leg brackets are under the plates,
proceed as follows:
- Attach a suitable load handling device
to the hollow disc unit.
The position of the hollow disc unit must
not change.
21
Publicité
