Publicité
4.1.4
Miscellaneous Faults
Display or Action
*** TAUT BELT ***
CHECK BELT ROLLERS
MAIN FILTER DIRTY
RECIRC FILTER DIRTY
OIL TEMPERATURE HIGH
OIL LEVEL LOW
Pellerin Milnor Corporation
Explanation
NOTE: This error message can appear only on machines
with 8088 processor software 97038I and later, or 80186
processor software version 20006D and later.
Goods are wrapped around the drive, tension, and/or tracking roll-
er, between the roller and the underside of the belt. This results in
an increased effective roller diameter and increased belt tension.
Unless corrected, the increased belt tension can damage the belt
or the bearings on either end of the the roller.
Observing all safety precautions, remove the wrapped goods from
the roller(s) as described in the service manual (see document
BIPPMM12 "Clearing Taut Belt Errors").
The main oil filter is dirty and needs to be replaced. Replace the
filter and return the press to normal operation.
The recirculation oil filter is dirty and needs to be replaced. Re-
place the filter and return the press to normal operation.
The hydraulic oil is too hot. This error shuts down the press. Press
to clear the error display. Wait for the oil to cool and return
the press to normal operation.
The hydraulic oil level has dropped too low. This error shuts down
the press. Press
to clear the error display. Add just enough oil
to prevent the error. Start the press and raise the ram. Check oil
level with the ram raised and add more oil as necessary.
BNP1VT01.C05 0000581207 B.2 7/26/24, 3:19 PM Released
Correcting Errors
37
Publicité
