Publicité
7. The controller lowers the discharge door.
The display shows "Waiting for Discharge Door Down."
8. The press checks if the "Ram Full Down" input is made:
•
NO: Continue to step 9.
•
YES: Skip to step 10.
9. The controller lowers the ram.
The display shows "Waiting for Ram Down."
10. Return to the Manual menu.
11. Turn the master switch to the OFF position (
3.1.5.1.1
To Remove Goods from the Belt
This sequence only occurs if there are goods on the belt when the operator initiates "Evening
Shutdown", which prevents the can from fully lowering.
1. The press checks if the "Ram at Unload" input is made:
•
YES: Skip to step 3.
•
NO: Continue to step 2.
2. The controller raises the ram until the input is made.
The display shows "Waiting for Ram at Unload Position."
3. The press checks if the "Can Full Up" input is made:
•
YES: Skip to step 5.
•
NO: Continue to step 4.
4. The controller raises the can.
The display shows "Waiting for Can Full Up."
5. The press checks if the "Discharge Door Full Up" input is made:
•
YES: Skip to step 7.
•
NO: Continue to step 6.
6. The controller raises the discharge door.
The display shows "Waiting for Discharge Door Full Up."
7. The controller runs the belt for 15 seconds or until the photoeye is blocked.
The display shows "Checking for Load on Belt."
8. The press checks if the "Discharge Photoeye" input is made (if the eye is blocked):
•
YES: Continue to step 9.
•
NO: Skip to step 10.
9. Press Escape or Signal Cancel to clear the error and return to the Manual menu. Return to
Section 3.1.5.1 : Evening Shutdown Procedure, page
Pellerin Milnor Corporation
) to power-down the press.
BNP1VO02.T02 0000580907 A.11 A.3 B.2 7/24/23, 3:55 PM Released
20.
Manual Operation
21
Publicité
