Publicité
2. Adjust or replace the switch if necessary.
E04 RAM NOT DOWN
PRESS FAULT RECOVERY
•
A double or especially large load is in the can. Remove some of the goods from under the
ram using the gaff hook supplied by the factory.
•
The ram in can switch (ram half up input) is malfunctioning or is out of adjustment.
1. Ensure the ram guide rod is below the ram in can proximity switch.
2. Ensure proper actuation of the switch per "Setting Single Stage Press Proximity Switch Posi-
tions" in the service manual.
3. Adjust or replace the switch if necessary.
E06 EYE BLOCKED
PRESS FAULT RECOVERY
•
There are goods on the end of the belt. Use the gaff hook to clear the goods from the belt.
•
The photoeye (belt eye input) is malfunctioning or is out of adjustment.
1. Ensure proper actuation of the photoeye.
2. Adjust or replace the photoeye if necessary.
E08 RECEIVE FAULT
PRESS FAULT RECOVERY
E09 TRANSFER FAULT
PRESS FAULT RECOVERY
Pellerin Milnor Corporation
Indicates the ram did not clear the ram in can proximity switch,
suggesting that the ram did not move down. Pressing
raises the ram. Press
tomatic operation. This error may be caused by the following
conditions:
Indicates that the discharge photoeye is blocked suggesting that
there are goods on the belt. The press cannot bring the can down
until this eye is cleared. Press
tion. This error may be caused by the following conditions:
This error applies to Miltrac™ loading only. Indicates Miltrac™
transfer was aborted by the loading device. This usually occurs
when the operator powers off the tunnel after it has committed to
transfer, but before the transfer has taken place. Pressing
clears the error and puts the press in manual mode.
This error applies to Miltrac™ discharge only. Indicates the re-
ceiving device aborted the transfer. This usually happens when
the receiving device loses the three-wire connection during opera-
tion (i.e., a safety plate is kicked, the
etc). Use the manual controls to move the shuttle back to the re-
ceive position. Pressing
press in manual mode. Manually discharge goods from the press.
Return to automatic mode and verify cake data when prompted.
again to lower the ram and return to au-
to return to automatic opera-
is pressed, power failure,
or
clears the error and puts the
Correcting Errors
once
or
31
Publicité
