Publicité
GB
IE
NI
Trouble shooting
In the event of an accident or malfunction, remove the battery from the device im-
mediately! Failure to comply may result in injuries from cuts.
Problem
Possible cause
Battery (
Appliance
Battery (
won't start
On/Off switch (
tive
Motor defective
Internal loose contact
Intermittent
On/Off switch (
operation
tive
Much
Trimming assembly dirty
vibration
Loud noise
Motor defective
The line spool (
not have enough cutting line
Both or one of the cutting line
is not protruding out of the
Bad trim
spool (
Trimming assembly dirty
Battery (
charged
20
17) discharged
17) not in
2) defec-
2) defec-
14) does
13)
17) not fully
Corrective action
Recharge battery (
separate operating instructions for the
rechargeable battery and charger)
Insert battery (
17) (Observe the sepa-
rate operating instructions for the rechar-
geable battery and charger)
Send in to Service Centre for repair
Send in to Service Centre for repair
Clean trimming assembly
(see „Cleaning and maintenance")
Send in to Service Centre for repair
If necessary, extend the cutting line (see
chapter "Device adjustments")
Replace the spool (see "Cleaning and
Maintenance").
Remove the spool and feed the cutting
line through the openings to the outside,
then reinstall the spool.
Clean trimming assembly (see „Cleaning
and maintenance")
Recharge battery (
separate operating instructions for the
rechargeable battery and charger)
17) (Observe the
17) (Observe the
Publicité
