HOLZMANN MASCHINEN TAS89M 230V Mode D'emploi page 27

When working metal it is possible for conductive dust to settle in the interior of the power
•
tool. The total insulation of the power tool can be impaired. Blow out the interior of the
power tool via the ventilation slots with compressed air.
13.2 Cleaning
Incorrect cleaning products can attack the finish of the machine. Do not use any
solvents, nitro thinners or other cleaning products that could damage the
machine's finish. Observe the specifications and instructions of the cleaning agent
manufacturer!
Regular cleaning guarantees the long service life of your machine and is a prerequisite for its safe
operation.
13.3 Storage
Store the machine including accessories in a dry, frost-proof and lockable place when not in use.
Cover the machine or store it in the original box to protect it from dust. Make sure that unauthorized
persons and especially children do not have access to the machine. Disconnect the machine from
the power supply.
Improper storage can damage and destroy important components. Only store packed
or already unpacked parts under the intended ambient conditions!
13.4 Disposal
Observe the national waste disposal regulations. Never dispose of the machine,
machine components or operating equipment in the residual waste. If necessary,
contact your local authorities for information regarding available disposal options. If
you purchase a new machine or equivalent equipment from your specialist dealer, he
is obliged in certain countries to dispose of your old machine properly.
14 TROUBLESHOOTING
Danger due to electrical voltage!
Handling the machine with connected power supply may result in serious injury or
death!
 Always disconnect the machine from the power supply before starting work to
repair defects and secure it against unintentional reconnection!
Many possible sources of error can be eliminated in advance if the machine is properly connected to
the power supply. If you are unable to carry out the necessary repairs properly and/or do not have
the required training, always consult a specialist to solve the problem.
Trouble
Machine stops or will not start
HOLZMANN MASCHINEN GmbH www.holzmann-maschinen.at
N O T E
W A R N I N G
Possible cause
 ON/OFF-switch damaged
 Saw unplugged
 Overload tripped
 Fuse blown or circuit breaker
tripped
 Cord damaged
N O T E
Solution
 Check the switch
 Check all power connections
 Allow motor to cool and reset
by pushing off switch
 Change fuse or reset circuit
breake
 Change cable
27
TAS89M_230V