Publicité
Stage 2. Installing the cover adapter on day device (using metal
Cover-adapters DN42/50/56 mm" (SKU#79124/79125/79126)
Select a cover adapter with an insert (bought separately) of the required
diameter depending on the outer diameter of the objective lens of the day
device.
The figures 42 mm, 50 mm, 56 mm in adapter's model name correspond
to the optical diameter of the lens of your day device.
Measure the outer diameter of the housing of the lens of your day device
and select an insert based on the data in the table below.
Example. If the lens diameter of your day device is 42mm, and the
measured outer diameter of the housing of the lens of your day device is
47.2 mm, you need to use an insert with marking "Ø 47".
Compatibility chart of inserts for day devices
42
45.5
46
46.5
46.7-47.6
47.7-48.6
48.7-49.6
49.7-50.6
50
51.6
53.4
54.7-55.6
55.7-56.6
56.7-57.6
57.7-58.6
58.7-59.6
56
59.7-60.6
60.7-61.6
61.7-62.6
62.7-63.6
63.7-64.6
64.7-65.6
Remove the cover (13) from the Cover by turning it counterclockwise.
Install the insert (14) into the adapter (15) all the way in (Fig.4)
Important! The insert must be installed with the narrowed part
facing downward.
Install firmly the adapter with the insert onto the objective lens (17) of an
day device (Fig.4).
Snap the lever (18) from the original OPEN position to the CLOSE
position (Fig.4). Check that the adapter firmly fits the objective lens.
If you see there is a clearance, please:
- Loosen the locking screw (19) with the hex-nut wrench (S=2mm).
Tighten the screw (20) with hex-nut wrench (S=4mm) with a clamping
force necessary to ensure that the adapter fits tightly the objective lens.
Tighten the locking screw (19).
8
45.5
46
46.5
47
48
49
50
51.6
53.4
55
56
57
58
59
60
61
62
63
64
65
It is recommended that you degrease the objective lens of your day
device and the inner side of the insert before installing the cover adapter.
Fig.4
Stage 3. Mounting CORE unit on a day device
Insert firmly the CORE unit with mounted attachment's eyepiece into the
cover adapter so that the pins in adapter's body enter grooves of the
attachment's eyepiece. Turn the CORE unit counterclockwise to hear a
click.
Tighten the screw (20) with the hex-nut wrench, to ensure that when turning
the lever, the adapter with insert tightly fits the objective lens of day device.
Mounting eyepiece on CORE unit
To mount the eyepiece on the unit, make sure that the lower salients (C) of
the eyepiece match the lower yellow salients (Fig. 5).
Insert the eyepiece into the unit's body and turn the locking ring (5)
clockwise.
Having turned the unit on, please make sure that the line of
horizon of you day device is parallel to the upper and lower edges
of the display of the CORE monocular.
С
wrong
correct
Pic.5
9
Publicité
