Publicité
circuited and resulted in battery damage or fire.
• Recharge only with the charger specified by the manufacturer.
3.3- Special warnings when using this product
• WARNING! Risk of cut. Keep your free hand or any body parts away from the chain cutters,
especially when the product installed with battery.
• Use suitable personal protective equipments, such as safety goggles, earmuffs, safety helmat,
non-skid safety shoes and safety gloves when using the tool.
• Always hold the chainsaw with your right hand on the rear handle and your left hand on the
front handle.
• When cutting a limb that is under tension be alert if spring back.
• Cut brush and saplings with extreme cautions. Slender materials may be caught by the tool
and ne whipped toward you or pull you off balance.
• Follow instructions for lubricating, chain tensioning and changing accessories.
• Keep proper footing and balance. Do not overreach. Overreaching can result in loss of balance
and can result in serious injury.
• Do not force this power tool, or the motor will be overloaded.
• Do not carry this product with finger on trigger.
• Do not use the tools in any operations that beyond the intended purpose.
• Do not operate the chain saw up in a tree. Operation of the tool while up in a tree may result in
personal injury.
• If the chain jamed on any electrical cord, do not touch the chain. It can become electrically live
and very dangerous.
• Maintain tool with care, keep the chain sharp, clean and well installed / aligned. Check the
chain before operation.
IV. GETTING STARTED
WARNING!
Before any intervention on product, ensure that power is set to the "OFF" position and
remove the battery pack.
4.1- Unpacking
• Remove the product from packaging.
• Check if the product and accessories (if any) are intact.
4.2- Content
• 1 chainsaw
• 1 guide bar
• 1 chain
• 1 scabbard
• 1 lubricant squeeze bottle
• 1 instruction manual
4.3- Assembly
Assembling guide bar and saw chain
• Position the chainsaw on a level surface.
• Turn the sprocket cover knob (9) anti-clockwise in order to remove the sprocket cover (7).
• Place a new chain around the guide bar, along top groove of guide bar, and around guide bar
nose. Make sure cutting edges of chain are in correct direction. Position the chain, so that the
Page 15 / 33
Publicité
