Publicité
Cleaning
Procedures
er cleaning. This is te avoid damage andpossibje
burn s,
Brand names are registered trademarks of the
, To Prevent staining or discobrati0n, clean appqiance after each use,
respective manufacturers.
!1: a Part is removed, be sure !t is correct!y replaced .
_*To order call 1-877-232-6771 USA or
1-800-688-8408 Canada.
PART
PROCEDURE
Removable Ramer Caps
Sealed Gas
° Allow burner to cool Remove burner cap and wash in soapy water with a plastic scouring pad. For
Burners
stubborn soils, clean with a soap-filled, nonabrasive pad or Cooktop Cleaning Creme_
(Part #20000001} _* and a sponge.
° Do not clean in the dishwasher or self-cleaning oven.
Sealed Gas Burners
° Clean frequently= Allow burner to cool= Clean with soap and plastic scouring pad. For stubborn soils,
clean with a soap-filbd, nonabrasive pad. Do not enlarge or distort holes.
° Be careful not to get water into burner ports.
° Use care when cleaning the ignitor= If the ignitor is wet or damaged the surface burner will not light=
Rumor Grates =
° Wash with warm, soapy water and a nonabrasive, plastic, scrubbing pad. For stubborn soils,
Porcelain on
clean with a soap-filbd, nonabrasive, plastic pad or Cooktop Cleaning Creme_ (Part #20000001} _*
Cast iron
and a sponge. If soil remains, reapply Cooktop Cleaning Creme_,cover with a damp paper towel and
soak for 30 minutes= Scrub again, rinse and dry.
° Do not clean in the dishwasher or sdf-cbaning
oven.
Clock and
° To activate control lock for cleaning, see "Locking the Controls" page 8=
Control Pad
° Wipe with a damp cloth and dry. Do not use abrasive cleaning agents as they may scratch the finish.
Area
, Glass cleaners may be used if sprayed on a cloth first= DO NOTspray
direcdy oo cootrolpad
and
display area.
Control Knobs
° Remove knobs in the OFF position by pulling forward.
° Wash, rinse and dry. Do not use abrasive cleaning agents as they may scratch the finish=
° Turn on each burner to be sure the knobs have been correctly replaced=
Ceoktop and
Porcelain enamel is glass fused on metal and may crack or chip with misuse, kis acid resistant, not acid proof.
Control Panel =
All spillovers, especially acidic or sugary spillovers, should be wiped up immediately with a dry cloth.
Porcelain Enamel
° When cool, wash with soapy water, rinse and dry.
, Never wipe off a warm or hot surface with a damp cloth This may cause cracking or chipping.
, Never use oven cleaners, abrasive or caustic cleaning agents on exterior finish of range.
Storage [}rawer
, When cool, wash with warm soapy water, rinse and dry. Never wipe a warm or hot surface with a damp
and [}oor
cloth as this may damage the surface and may cause a steam burn.
Handles =
° Forstubborn soil, use mildly abrasive cleaning agents such as baking soda paste or Bon Ami*. Do not use
Painted Fnamei
abrasive cleaners such as steel wool pads or oven cleaners. These products will scratch or permanently
damage the surface.
Note: Use a dry towel or cloth te wipe up spills, especially acidic or su_jary spills. Surface may
discolor or dull if soil is not immediately
removed. This is especially important
for white surfaces.
coi_tinued.
. .
2O
Publicité
