Télécharger Imprimer la page

Maytag Precision Touch Control 800 Instructions page 9

Publicité

To set the Clock:
1. Press the Clock pad.
, The time of day flashes in the dispiay.
2. Press the appropriate number pads to set the time of day.
, Cobn flashes in the dispiay.
3. Press the Clock pad again or wait four seconds.
, The cobn will remain on.
When ebctrbd
power is suppibd or after a power
interruption, the Hastchock time before power was
interrupted will flash.
To recall the time of day when another time function is
showing, press the Clock pad.
CHocktime cannot be changed when the oven has been
programmed for Dday Cook or Cban, or Cook & Hoid.
To cancel
the Clock display:
If you do not want the time of day to dispiay:
Press and hoM the CANCEL and Clock
pads for three seconds. The time of day
will disappear from the dispiay.
When the chock display is canceled, press
the Clock pad to briefly display the time of
day.
When the clock display is canceled, after 15 minutes, the oven
control will go into Standby Mode to save energy. The displaywill
be blank and the oven light will not operate. To "wake up" the
control from Standby Mode, press any touchpad. A double beep
will sound,
_,s_iii!_,!i,_i!i_!_i!iiiiiiiiiiiii!iiiiii!i{!ii!ile
',_'_
To restore
the Clock display:
Press and hoM the CANCEL and Clock pads for three
seconds. The time of day will reappear in the display.
The timer can be set from one minute (0:01} up to 99 hours
and 59 minutes (99:59}.
The timer can be used independently of any other oven
activity. It can also be set while another oven function is
operating.
The timer does not control the oven. It only controls a beeper.
To set the Timer:
1. Press the Timer pad.
, 0:00 and TIMER flash in the display.
2. Press the appropriate number pads until the correct time
appears in the display.
, The colon and TIMER will continue to flash.
3. Press Timer pad again or wait four seconds.
, The colon stops flashing and the time begins counting
down.
, The last minute of the timer countdown will be displayed
in seconds.
4. At the end of the set time, one long beep will sound and
"End" will be displayed.
5. Press the Timer pad to clear the display.
To cancel
the Timer:
1. Press and hold the Timer pad for three seconds.
OR
2. Press the Timer pad and press '0'
using the number pads.
--0
Autoset
Locking
the Contro
and Oven Door
The touchpad and oven door carl be locked for safety,
cleaning, or to prevent unwanted use. The touchpads will not
function when locked.
If the oven is currently in use, the touchpads and door cannot
be locked.
The current time of day wiii remain in the display when the
touchpads and door are locked.
To lock:
Press and hold the CANCEL and Cook &
Hold pads for three seconds. (Press the
CANCEL pad first.}
, OFFappears in the display
, LOCK flashes while the door is
locking.
To unlock:
Press and hold the CANCEL and Cook & Hold pads for three
seconds. (Press the CANCEL pad first.} OFF disappears from
the display.
Note: The touchpads and oven door cannot be locked if
the oven temperature is 400° F or above.
Faumt Codes
BAKE or LOCK may flash rapidly in the display to alert you if
there is an error or a problem. If BAKE or LOCK flash in the
display, press the CANCEL pad. If BAKE or LOCK continue to
flash, disconnect power to the appliance. Wait a few minutes,
and then reconnect power. If the flashing still continues,
disconnect power to the appliance and call an authorized
servicer.

Publicité

loading