MAINTENANCE
Check the engine oil level before each use or every 8
hours of operation.
Place the generator on a level surface and allow the
engine to cool for several minutes.
Remove the oil dipstick and wipe the dipstick clean.
3. See Figure 2. Insert, then remove the oil dipstick.
4.
engine oil incrementally and recheck until the level is at
top notch on the dipstick, drain the oil to reduce the oil
level to the full mark.
When using the generator in dusty conditions or
extremely hot weather, change the oil more frequently.
Change the oil while the engine is still warm from
operation.
Place the generator on a level surface and allow the
engine to cool for several minutes.
3. See Figure 3. Place an oil pan (or suitable
container) under the oil drain hose.
4. Unclip the oil drain hose and twist the cap
counterclockwise to allow the oil the to drain.
24 |
3
Twist the cap clockwise to close. Secure the hose in the
hose clip.
See Figure
by rotating it counterclockwise. Allow the oil
to drain
the engine.
Install by hand, turning clockwise until the seal contacts
the engine then turn another 3/4 turn. DO NOT over
tighten.
See Figure 5. Fill with the recommended oil. Stop
frequently to check the oil level. Do not overfill. If the
engine is overfilled, the excess oil may get transferred
to the air cleaner housing and air filter. An indication of
overfilling is white or blue smoke coming from the muffler
when the engine is running.
1.7 Quart (1.6 Liter)