mundoclima Aerotherm BCC 200 CONNECT Manuel D'installation, D'utilisation Et D'entretien page 96

Any use other than intended does not involve
the manufacturer in any commitment or
obligation.
Hydraulic system
Components
Selection and installation of system components
must be carry out by installer.
Water quality
The water quality is determined by the following
factors, avoid therefore:
Inorganic salts

pH

Biological load (seaweeds etc)

Suspended solids

Dissolved oxygen

Water with inadequate characteristics can cause:
pressure drop increase

energy efficiency decrease

corrosive symptom increase

Risk of freeze
If the unit or the relative water connections can
be subject to temperatures close to 0°C adopt
measures for prevent risk of freeze.
The appliance is intended to be permanently
connected to the water mains and not connected
by a hose-set .
The water may drip from the discharge pipe of
the pressure-relief device and that this pipe must
be left open to the atmosphere.
The pressure-relief device is to be operated
regularly to remove lime deposits and to verify
that is not blocked.
A discharge pipe connected to the pressure-relief
device is to be installed in a continuously
downward direction and in a frost-free
environment.
1 SAFETY CONSIDERATION S