mundoclima Aerotherm BCC 200 CONNECT Manuel D'installation, D'utilisation Et D'entretien page 149

Power supply
Check the connection between power supply plug and socket and
ground wiring regularly;
Electronic anode
The unit is equiped with a dynamic system for the tank active
protection from corrosion.
The anode is in active titanium.
Periodical substitutions are not foreseen or maintenance.
Filter cleaning
The air filter blocks dust.
If the filter is blocked, the unit will not work as well.
The operating with clogged filters leads to a reduction of the air
flow, leading to malfunctions and unit shutdowns.
Approximately, cleaning should ideally take place between weekly
and monthly. It is advisable to start with frequent checks, and to
adjust the frequency based on how much dirt is discovered.
A Air outlet
B Air inlet
C Air filter
In terms of the filter set in air inlet directly (namely, air inlet
without connect with canvas), the method of dismantle the filter
is:
anti-clockwise unscrew the air inlet (1) ring, take out the

filter (2) and clean it completely, finally, remount it to the
unit.
Condensate discharge
Dust and deposits could cause obstructions .
In addition in the pan can proliferate microorganisms and
moulds.
It is very important to provide a periodic cleaning with
appropriate detergents and in case a disinfection with sanitizing
products.

After cleaning pour water into the pan to ensure a regular
flow.
11 MAINTENAN CE
Unit 200 Unit 300
Drain pan