mundoclima Aerotherm BCC 200 CONNECT Manuel D'installation, D'utilisation Et D'entretien page 112

Installing the unit in any of the following places may lead to
malfunction:
The site contains mineral oils such as cutting lubricant

Seaside where the air contains much salt.

Hot spring area where corrosive gases exist, e.g., sulfide gas.

Factories where the power voltage fluctuates seriously.

The place with direct sunlight and other heat supplies. If

there's no way to avoid these, please install a covering.
Place like kitchen where oil permeates.

Place where strong electromagnetic waves exist.

Place where flammable gases or materials exist.

Place where acid or alkali gases evaporate.

Consider sound emission
Noise levels could represent an inconvenience if installed in areas
that require extreme silence, example near bedrooms
Functional spaces
Unit
Diameter A
If installed in inclosed space
The unit must be located in a space >15m³, and must have
unrestricted air flow.
Make sure there is enough Installation space.
For optimal efficiency and serviceability, the following clearances
should be maintained:
400mm on the air inlet side;

400mm on the air outlet side;

600mm in the back;

600mm in the front.

5 SELECTIN G THE INSTAL LATION SITE
NO TE
200
560
300
650
Barriera