mundoclima Aerotherm BCC 200 CONNECT Manuel D'installation, D'utilisation Et D'entretien page 129


If the unit has been tipped during transport, wait at least 2
hours before starting it up
General
The indicated operations should be done by qualified technician
with specific training on the product.
Upon request, the service centres performing the start-up.
The electrical, water connections and the other system works are
by the installer.
Agree upon in advance the star-up data with the service centre.
Before checking, please verify the following:
the unit should be installed properly and in conformity with

this manual
the electrical power supply line should be isolated at the

beginning
the unit isolator is open, locked and equipped with the

suitable warning
make sure no tension is present


After turning off the power, wait at least 5 minutes before
accessing to the electrical panel or any other electrical
component.
 Before accessing check with a multimeter that there are no
residual stresses.
 Before starting the unit, make sure that the room is free of
dust and debris and that the conduits are not blocked
The following check list is a brief reminder of the points to
check and of the operations to perform to start-up the unit.
For details refer to the various chapters in the manual.
9 START-UP
N ote
Warning
N ote