Hatco Glo-Ray GRHW-2P Manuel D'installation Et D'utilisation page 13

English
4-Sided Sign Holder
A 4-sided sign holder is available as an accessory for the
GRHW-1SG model only. Use the following procedure to install
the 4-sided sign holder.
1. Remove the four upper screws from the top four corners of
the unit.
2. Align the bottom screw holes on the front and rear long
sign holder brackets with the screw holes on the unit.
3. Secure the two long sign holders to the unit using the
previously removed screws.
Long
Sign Holder
Screw
Installing the Front and Rear Long Sign Holders
4. Install the side sign holders to the front and rear long sign
holders. To install a side sign holder:
a. Clip the hemmed top edge the side sign holder over the
top edge of the front and rear long sign holder brackets.
At the same time, guide the threaded studs near the
bottom of the side sign holder through the mounting
holes on the front and rear long sign holder brackets.
Rear Long
Sign Holder
Hemmed Hemmed
Front Long
Sign Holder
Installing a Side Sign Holder
b. Secure the side sign holder to the two long sign holders
by attaching the supplied cap nuts to the threaded studs.
Form No. GRHWM-0520
Side Sign
Holder
Edge Edge
OPTIONS AND ACCESSORIES
Threaded
Side
Sign
Holder
Long Sign
Holder
Brackets
Securing the Side Sign Holders
4" (102 mm) Adjustable Legs
4" (102 mm) adjustable legs are available as an accessory
for GRHW-1P and GRHW-1SG models and are standard on
GRHW-2P models.
Overhead Heat Controls
Overhead heat controls are available options for GRHW-1P,
-2P, -1SG, and -1SGS models. An infinite control allows the
operator to manually adjust the upper heat output from full
wattage down to any desired level.
Hardcoated Bin
Hardcoated bins are available
as accessories for GRHW-1SG,
GRHW-1SGS, and GRHW-
1SGD models. The dimensions
of hardcoated bins
4"W x 13-1/4"D
(102 x 337 x 25 mm).
Chef LED Bulbs
Chef LED bulbs are available for all Mini-Merchandisers. Chef
LED bulbs are LED light bulbs that offer energy savings over
incandescent bulbs. Use the following for replacement bulbs:
120 Volts
2700K: R02.30.185.01
3000K: R02.30.195.01
4000K: R02.30.196.01
230 Volts
2700K: R02.30.197.01
3000K: R02.30.198.01
4000K: R02.30.199.01
13
Stud
Cap
Nut
are
x 1"H