Installing The Side Panels - Hatco Glo-Ray GRHW-2P Manuel D'installation Et D'utilisation

INSTALLATION
GRHW-1SGD and GRHW-1SGDS Models
1. Align the four holes in the sneeze guard and support trim
with the four studs located underneath the front top of the
unit.
2. Secure the sneeze guard and support trim to the studs with
the four supplied cap nuts. Do not over-tighten the cap nuts.
Sneeze Guard
Support Trim
Installing a Sneeze Guard
(GRHW-1SGDS model shown)

Installing the Side Panels

Some models are shipped with side panels. Use the appropriate
procedure to install side panels on a unit.
GRHW-1P, -2P, -1SG, and -1SGS Models
The above models can be equipped with polycarbonate side
panels. To install a polycarbonate side panel:
NOTE: Make sure to install the sneeze guard before installing
side panels, if equipped.
1. Align the four holes in the side panel with the corresponding
holes in the two support posts.
• Make sure the slanted edge of the side panel is aligned
with the sneeze guard.
Stud
Cap Nut
GRHW-1SGD and GRHW-1SGDS Models
All GRHW-1SGD and GRHW-1SGDS models are equipped
with glass side panels. To install a glass side panel:
NOTE: Side glass panels have a special "Low E" coating
8
2. Secure the side panel to the support posts using the four
supplied screws. Do not over-tighten the screws.
Polycarbonate
Side Panel
Screw
Polycarbonate Side Panel Installation
(GRHW-1SG model shown)
1. Remove the two screws from the Z bracket and remove
bracket.
2. Place glass side panel into the bottom brackets.
3. Re-install the Z bracket with the two screws previously
removed.
Screws
Z Bracket
Glass
Side
Panel
"OUT"
Facing
Outward
Glass Side Panel Installation
(GRHW-1SGDS model shown)
applied to one side to help reduce heat loss through
the glass. The "Low E" coated side must face inward
and the word "OUT" on the glass must face outward.
English
Support
Post
Form No. GRHWM-0520