Publicité
equipped with a 2-point seat belt. 22).
f ) Ensure that the waist part of the vehicle seat belt is positioned
correctly across the child's hips.
g) If used in a vehicle equipped with rear vehicle seat belts with
integrated air bags (inflatable seat belts), the interplay be-
tween the inflatable portion of the seat belt and this child re-
straint system could cause serious injury or death. When using
the car seat in vehicles equipped with rear vehicle seat belts
with integrated air bags (inflatable seat belts), follow the car
manufacturer's instruction manual.
h) Make sure that the buckle of the car's three-point seat belt is
not too high. Otherwise, try to install the car seat on a different
seat in the vehicle. In some cases, the vehicle seat belt buckle
may be too long and exceed the expected height from the
bottom part of the seat (Fig. 23). In this case the seat must not
be fixed on that seat but must be installed on another seat on
which there is no problem. For more information, contact your
car manufacturer.
How to clean the fabric cover
The seat cover is fully removable and can be machine washed at
30°C; the reducer cushion is machine washable at 30°C. Please refer
to the cleaning instructions on the fabric label which illustrates the
following washing symbols:
Machine washable at 30°C.
30° C
Do not bleach
Do not tumble dry
Do not iron
Do not dry clean
Never use abrasive detergents or solvents. Do not dry the fabric cover
within a dryer, let it dry without squeezing it.
The fabric cover must only be replaced with another cover approved
by the manufacturer, since it is an integral part of the child car seat
and, therefore, one of its safety elements.
WARNING! To ensure the safety of the child car seat, never use it
without its fabric cover.
To remove the fabric cover follow the instructions below:
Cover
• Unfasten the car seat harnesses;
• Remove the shoulder straps;
• Use the buttons to unfasten the central flap of the cover;
• Pull the cover off.
Headrest
• Raise the flap located at the base of the headrest;
• Pull off the headrest.
How to clean the plastic and metal parts
Clean the plastic and coated metal parts with a damp cloth only. Nev-
er use abrasive detergents or solvents. The moving parts of the child
car seat must not be lubricated.
Checking the condition of the components
It is recommended to regularly check the condition of the following
components to make sure they are not damaged or worn:
55
Publicité
