Publicité
General Power Tool Safety Warnings
6. Service
a. Have your power tool serviced by a
qualified repair person using only
identical replacement parts. This will
ensure that the safety of the power tool
is maintained.
a. Always assume that the tool contains
fasteners. Careless handling of the tool
can result in unexpected firing of fasten-
ers and personal injury.
b. Do not point the tool towards yourself
or anyone nearby. Unexpected trigger-
ing will discharge the fastener causing
an injury.
c. Do not actuate the tool unless the tool
is placed firmly against the workpiece.
If the tool is not in contact with the
workpiece, the fastener may be deflect-
ed away from your target.
d. Disconnect the tool from the power
source when the fastener jams in the
tool. While removing a jammed fastener,
Do not fire fasteners into walls or floors
without assuring the area on the opposite
side is clear. A fastener could travel through
the work surface, causing property damage
or injury.
Do not drive fasteners into walls, floors,
or other work areas without knowing what
may be damaged by the driven fastener.
Fasteners driven into live electrical wires,
plumbing, gas piping, or other types of ob-
structions can result in electrocution, explo-
sion, personal injury and/or property dam-
age.
Hold the power tool by identified insulat-
ed gripping surfaces when performing an
operation where the fastener may contact
hidden wiring. Fasteners contacting a "live"
wire may make exposed metal parts of the
Cordless Stapler Safety Warning
Additional Safety Warnings
SAVE THESE INSTRUCTIONS
b. Never service damaged battery packs.
Service of battery packs should only
be performed by the manufacturer or
authorized service providers.
the stapler may be accidentally activated
if it is plugged in.
e. Use caution while removing a jammed
fastener. The mechanism may be under
compression and the fastener may be
forcefully discharged while attempting to
free a jammed condition.
f. Do not use this tacker for fastening
electrical cables. It is not designed
for electric cable installation and may
damage the insulation of electric cables
thereby causing electric shock or fire
hazards.
power tool "live" and result in electric shock
or electrocution.
Do not tamper with, remove, or cause sta-
pler operating controls to become inopera-
ble. Missing or improperly operating stapler
controls can cause unexpected actuation
and personal injury.
Never keep a finger on the trigger when
not driving fasteners or carrying the tool.
Carry the tool only by the handle. Keeping a
finger on the trigger when carrying the tool,
or when not driving fasteners can result in
unintentional triggering and personal injury.
When loading fasteners ensure that the
fastener heads align with the nosepiece of
the tool. If fasteners are not aligned with the
nosepiece, tool may jam or misfire causing
property damage or injury.
5
Publicité
