Publicité
Trouble
The driven fasteners
bend or break.
The stapler skips fasten-
ers or has a cycle feed
that is too large.
Fastener are frequently
jamming.
Fasteners do not slide
into magazine.
24
Troubleshooting
Cause
Fastener is too long.
Work surface too hard.
The driver blade is dam-
aged.
Fasteners used are not ap-
proved.
Fasteners used are not ap-
proved.
The fasteners are old, adhe-
sion between fasteners is
worn.
Dust or debris in magazine.
Action
Select shorter fastener per
"Fastener Selection" table on
page 11.
Use the stapler only on wood
and wood products.
Return to Bosch service center
for service.
Only use approved fasteners.
See "Specifications" table on
page 10.
Only use approved fasteners.
See "Specifications" table on
page 10.
Use new fastener strips.
Inspect the magazine and clear
any residual material build-up
or any foreign matter.
Publicité
