Publicité
Trouble
Stapler does not oper-
ate.
No actuation occurs.
Fastener jammed.
Underdriven fasteners.
Overdriven fasteners.
Troubleshooting
Cause
No battery inserted, battery
discharged.
Battery and tool tempera-
ture too low.
Stapler not switched on.
Sequential operation has
not been conducted cor-
rectly.
Workpiece contact is not
fully depressed.
Dry fire lock out activated,
minimum amount of fasten-
ers left in the magazine.
Fastener jammed.
Fasteners used are not ap-
proved.
Magazine is empty.
Debris, dirt, or jammed
fastener in nosepiece and/
or magazine.
Depth of drive is not set
deep enough.
Fastener is too long.
The battery is discharged or
defective.
Depth of drive is set too
deep.
Fastener is too short.
Action
Insert charged battery.
Allow battery and tool to warm
up sufficiently to operating am-
bient temperature. See "Specifi-
cations" on page 10.
Press On/Off Button 6 for 1.5
seconds. (See Fig. 1.)
See "Stapler Actuation" on page
18.
See "Stapler Actuation" on page
18.
Refill the magazine. See "Load-
ing the Magazine" on page
14.
See "Jam Clearing" on page
22.
Only use approved fasteners.
See "Fastener Selection" on
page 11.
Refill the magazine. See "Load-
ing the Magazine" on page
14.
See "Jam Clearing" on page
22.
Adjust depth setting wheel
to increase drive depth. See
"Depth of Drive Adjustment" on
page 18.
Only use approved fasteners.
See "Specifications" on page
10."Fastener Selection" on
page 11.
Insert charged battery. See
"To Insert the Battery Pack" on
page 12.
Adjust depth setting wheel
to decrease drive depth. See
"Depth of Drive Adjustment" on
page 18.
Only use approved fasteners.
See "Specifications" on page
10."Fastener Selection" on
page 11.
23
Publicité
