Publicité
6. Connect the two test probes in parallel to the object that you want to measure.
Connect the red test probe to the positive terminal and the black test probe to
the negative terminal.
à
The display shows the measured value and polarity.
à
The display shows "-" before the reading if the value is negative.
à
The display shows "OL" if the measured value exceeds the max. permiss-
ible value.
7. Remove the test probes from the measured object.
8. Switch the multimeter off by rotating the dial to the position OFF.
9.3 Measuring AC voltage
Measure AC voltage up to 600 V/AC.
1. Switch the multimeter off by rotating the dial to the position OFF.
2. Connect the red test lead to the measurement socket V mA.
3. Connect the black test lead to the measurement socket COM.
4. Rotate the dial to V.
à
The display shows "AUTO" to indicate that auto-range selection is activated.
5. Repeatedly press the button MODE until the symbol
6. Connect the two test probes in parallel to the object that you want to measure.
à
The display shows the measured value.
à
The display shows "OL" if the measured value exceeds the max. permiss-
ible value.
shows on the display.
45
Publicité
