Publicité
2.3 - ADJUSTING RIDING SETTING OF FRONT DERAILLEUR
(WITH V2 / V3 POWER UNIT)
If you are using the front derailleur with the
V2 / V3 EPS Power Unit, follow the procedure
given below.
The setting adjustment procedure is used to
change the position of the front derailleur
relative to the individual chainrings.
Place the front derailleur on the chainring for
which you intend to adjust the position. To
C
D
adjust the setting, press and hold the MODE (D
A
- Fig.5) button on the Ergopower EPS controls
for approximately 6 seconds until the purple
B
LED illuminates.
5
Adjust the position by pressing lever B or C on
the left hand control set (Fig. 5).
Note
The system moves the front derailleur by a fixed increment of approximately 0.1 mm
each time lever B or C is pressed (Fig. 5).
To store the new setting, press the MODE button on the Ergopower EPS controls briefly
(D - Fig.5).
ENGLISH
24
Publicité
