Publicité
Reinstall the wiring cover and attach it to the hood using
2.
the retaining screw
. Ensure the tabs on the inner top
of the hood are engaged in the wiring cover slots
not pinch the wires when you reinstall the wiring cover.
5.5 Installing the filters
Ducted installation only:
1.
Re-install the grease filters previously removed.
‒
Non-ducted installation only:
2.
Purchase 2 non-ducted filters from your local
‒
distributor or retailer. See rating plate for filter type.
→ "Rating plate location", Page 18
Attach the non-ducted filters following instructions
‒
included with the non-ducted filters.
6 Installer checklist
Installer checklist
Final check
Installer checklist
Specified clearances maintained to cabinet
surfaces.
Appliance is level.
All packaging material removed.
Proper ground connection.
Owner is aware of location of the main circuit
breaker.
INSTALLER: Write the model number and serial
number in the Use and Care Manual. Leave the
Use and Care Manual and Installation Instructions
with the owner of the appliance.
To clean and protect exterior surfaces
¡ Clean the stainless steel surfaces by wiping with a
damp soapy cloth. Rinse with clear water and dry with a
soft cloth to avoid water marks. Remove fingerprints
and smears with mild glass cleaner.
¡ To polish and protect stainless steel, apply a stainless
steel conditioner with a soft cloth. The Thermador
Stainless Steel Conditioner is available for purchase in
the online accessories store (US only) www.bosch-
home.com/us/shop.
¡ Do not use conditioner on non-steel surfaces, logos,
control markings, labels, black or smudge-proof
. Do
stainless steel, and appliance interiors.
¡ DO NOT allow deposits to remain for long periods of
time.
¡ DO NOT use ordinary steel wool or steel brushes. Small
bits of steel may adhere to the surface causing rust.
¡ DO NOT allow salt solutions, disinfectants, bleaches or
cleaning compounds to remain in contact with stainless
steel for extended periods. Many of these compounds
contain chemicals which could prove harmful. Rinse
with water after exposure and wipe dry with a clean
cloth.
Troubleshooting
See the Use and Care Manual for troubleshooting
information.
Refer to the Limited Product Warranty in the Use and Care
Guide. Please be prepared with the information printed on
your product data rating plate when calling.
7 Customer Service
Customer Service
With any warranty repair, we will make sure your
Customer Service
appliance is repaired by an authorized service provider
using genuine replacement parts. We use only genuine
replacement parts for all repairs.
Detailed information on the warranty period and terms of
warranty can be found in the Statement of Limited Product
Warranty, from your retailer, or on our website.
If you contact Customer Service, you will need the model
number (E-Nr.) and the production number (FD) of your
appliance.
The LED light sources are available as a spare part and
should only be replaced by an authorized service provider.
USA:
1-800-944-2904
www.bosch-home.com/us/owner-support/get-support
www.bosch-home.com/us/shop
CA:
1-800-944-2904
www.bosch-home.ca/en/service/get-support
www.bosch-home.ca/en/service/cleaners-and-accessories
7.1 Model number (E-Nr.) and production
number (FD)
You can find the model number (E-Nr.) and the production
number (FD) on the appliance's rating plate.
Making a note of your appliance's details and the
Customer Service telephone number will enable you to
find them again quickly.
Installer checklist en-us
17
Publicité
