Publicité
en-us Installation instructions
Remove the mounting bracket. Using a ⁷⁄₆₄" drill bit, drill
5.
3 holes where marked.
Assemble the mounting bracket to the side frame using
6.
a flathead screwdriver and 3 of the provided
countersunk wood screws. Repeat for the other cabinet
side.
Installing the hood
Run the house power cable between service panel and
1.
hood location.
14
There are 2 pairs of recessed holes on each side of the
2.
top of the hood:
and
front. These holes allow the range hood to hang on the
mounting brackets.
Horizontal exhaust installation only:
3.
Temporarily hang the hood on the mounting brackets
‒
using its 2 recessed rear holes (
holding the hood, run the house power cable into the
hood through the strain relief previously installed.
Unhook the rear holes from the mounting brackets and
hang the hood using its 2 recessed front holes (
). While holding the hood, continue with connecting
the ductwork (skip to step "Ducted installation only").
Vertical exhaust installation and non-ducted
4.
installation only:
Hang the hood on the mounting brackets using the 2
‒
recessed front holes (
hood, tighten an appropriate strain relief with ½"
diameter (not included) to the power cable, then
insert the strain relief in the knockout hole.
Ducted installation only:
5.
Connect the ductwork to the hood and use metal foil
‒
duct tape to make the joints secure and air-tight.
Make sure the damper assembly, or the round duct
plate enters the ductwork and that the damper opens
and closes freely.
‒
on the rear,
and
at the
and
). While
and
and
). While holding the
Publicité
