Publicité
Protect the product against
heat. Do not place the product
close to open flames or heat
sources such as stoves or
heating appliances.
˜ Before first use
1. Remove the packaging material.
2. Clean the product (see "Cleaning and
care").
NOTES:
The first few times the product is heated up, a
o
faint odour may be present. Ensure sufficient
ventilation in the area.
Discard the first set of toasted bread slices.
o
Set the browning level to at least level 4 for
o
the first use.
˜ Operation
1. Unwind the mains cord
rewind
before use.
[
4 ]
2. Connect the mains plug
mains socket.
˜ Toasting bread
NOTES:
The toasting result depends, among other
o
things, on the type, moisture, and freshness
of the bread.
Dry or white bread browns quicker than fresh
o
or dark bread.
Insert the slice of bread in the centre of the
o
toasting slot
to achieve even browning.
1 ]
[
We suggest browning level 3 for golden
o
browning when toasting 2 slices of bread.
Browning level 6 causes a very strong
o
browning. Thick bread slices may cause
smoke to form. In this case, stop the toasting
process: Press
2 ]
[
If you only want to toast a single slice of
o
bread, use a lower browning level than for
toasting 2 slices of bread.
1. Insert a slice of bread into each toasting
slot
.
1 ]
[
10 GB/IE/NI
from the cord
3 ]
[
to a suitable
3 ]
[
.
Do not use bread slices that are too thick.
The bread must not be jammed in the toast
slot.
2. Set the browning level: Set the control
dial
to one of the browning levels,
[
7 ]
from 1 to 6.
1 = very light toasting/light browning
6 = very strong toasting/very strong
browning
3. Press down the lever
place. The bread is lowered. The product
switches on.
NOTE: The lever
8 ]
[
the mains plug
3 ]
[
socket.
4. When the toasting process is finished, the
bread is lifted up. The lever
upwards.
5. Remove the bread from the toasting slot
˜ Cancel toasting
Press
. The lever
2 ]
[
o
˜ Cleaning and care
DANGER! Risk of electric shock!
m
Before cleaning: Always disconnect the
product from the mains supply.
DANGER! Risk of burns! Do not clean
the product right after operation. Let the
product cool first.
WARNING! Do not immerse the product's
m
electrical components in water or other
liquids. Never hold the product under
running water.
Part
Cleaning method
Housing
o
o
o
until it clicks into
[
8 ]
only engages when
is connected to a mains
moves
[
8 ]
1 ]
[
moves upwards.
8 ]
[
Wipe down the housing
with a slightly damp
cloth.
Do not let any water or
other liquids enter the
product interior.
.
Publicité
