Assembly; Assembling The Aluminium Tube; Assembling The Electrical Floor Brush, The 2 In 1 Brush Or The Crevice Nozzle; Operating Instructions - Rotel U6082CH Mode D'emploi

• ASSEMBLY

Assembling the aluminium tube

o Fit the tube into the main unit's air inlet until it clicks into position.
o To remove the tube, hold the main unit, press the release knob and remove the tube.

Assembling the electrical floor brush, the 2 in 1 brush or the crevice nozzle

o Fit the required accessory into the tube or the main unit's air inlet until it clicks into
position.
o To remove the accessory, hold the aluminum tube or the main unit, press the release
knob and remove it.

• OPERATING INSTRUCTIONS

o Use the electrical floor brush for removing dust on hard floor and carpet.
o Use the 2 in 1 brush or crevice nozzle for furniture, curtains, in corners and awkward
crevices.
o There are two buttons, an on/off- and a power level-button.
o To switch the unit on, press the on/off-button, it starts at normal speed.
o To change between normal and high speed, press the power level-button.
o To switch the unit off, press the on/off-button.
o During operation, please pay attention to the charging indicators. The indicators will
go out gradually as the level of charge reduces and the appliance will stop working
automatically when all the indicators have gone out.
Gebrauchsanweisung ○ Mode d'emploi ○ Istruzioni per l'uso ○ Instruction for use
34