Publicité
1.4 LC-Display and Buttons
On the LC-Display all operating parameters such as RF and AF level will be shown.
Using the "Menu" button you can select from 6 options. The selected function is surrounded
by a square frame and shown on the upper half of the LC-Display. Functions and operation are
described in the following.
1.4.1 Diversity Indication of the Receiving Channel
Each receiving module has two separate receiving circuits, one for each antenna. The
signal with the better S/N ratio is switched to the output. The received diversity channel (A or
B) is shown on the LC-display.
1.4.2 Reading the AF- and RF-Level
The AF- or RF- level can be read on the LC-display.
1.4.3 Group, Channel
•
If "G/CH" is selected, the Group and Channel are shown on the display.
•
Press the "Group" button once and the number above GROUP will start flashing. Push the
"Group" button now to change to another pre-programmed group. Press the "Menu"
button to confirm the selected group. The number above GROUP will stop flashing.
•
Press the "Scan" button to select a channel automatically. The number above CHANNEL
will start flashing. Press the "Scan" button once again and the receiver will adjust an
interference-free channel automatically. Press the "Menu" button to confirm the selected
channel. The number above CHANNEL will stop flashing.
32
Publicité
