Publicité
Rear view NE 500 S
(5)
Antenna input B. TNC socket. With power supply for antenna amplifier.
(6)
AF output, 3-pin XLR, balanced
(7)
Mic/Line level switch for AF output (6) and (8). "Mic" for microphone level, "Line" for
line out level
(8)
AF output, 1/4" jack (6.35 mm), unbalanced
(9)
Computer network interface connector
(10)
DC connection for power supply unit, 12 V DC
(11)
Antenna input A. TNC socket. With power supply for antenna amplifier.
(12)
Mounting bracket for 19"-mounting
1.2 Connecting Antennae
Connect the antennae to the TNC sockets (5) and (11) and set them at an angle (60°).
Please note that for diversity operation both antennae have to be connected. A weighting
circuit silently switches the signal with the better S/N ratio to the output.
Important:
Avoid obstacles between antennae and transmitters, otherwise the reception could be disturbed.
1.3 Setting up
1. Place the NE 500 diversity receiver in the same room or area as the transmitters. Ensure
that the NE 500 is installed as close as possible to the mixing console or amplifier so that
the display can be seen at all times.
2. Do not place the NE 500 receiver near digitally controlled equipment.
3. Connect the AF-output (6) or (8) to the corresponding input of the mixing console or
amplifier.
4. Connect the receiver to AC power.
5. Switch on the receiver (2). The red LED will illuminate.
5
6
7
8
9
10
11
12
31
Publicité
