Miele PW 6323 Schéma D'installation page 31

BSK = Payment
system kit
BSS peak-load ne-
gotiation kit
XKM RS232 com-
munication mod-
ule
Optional accessories
Only use genuine Miele spare parts and accessories with this ma-
chine.
Using spare parts or accessories from other manufacturers will in-
validate the warranty, and Miele cannot accept liability.
The washing machine can be equipped with a payment system (e.g.
for self-service operations) using the optional BSK payment system
kit. This must be connected and programmed by a Miele Service tech-
nician. Payment systems with mechanical or electronic coin validator
are available from Miele as optional accessories for individual target
groups.
The programming required for connecting a payment system must be
carried out by Miele Service or an authorised Miele dealer only. A
separate electrical connection is not required for a payment system.
The washing machine can be connected to a peak-load shut-off or an
energy management system using a BSS peak-load negotiation kit
which is available as an optional accessory.
The peak-load cut-out monitors the energy consumption of a system
and deactivates individual pieces of equipment temporarily in order
to ensure that certain total load limits are not exceeded. Monitoring
is externally controlled.
The kit provides three signal contacts and a neutral conductor via a
terminal block. The terminal block is marked with "a", "b", "c", and "d".
Output signal, start of machine operation
a
Output signal, machine heating request
b
Peak-load input signal, machine heating deactivated
c
Neutral conductor
d
When the peak-load function is activated the current programme is
stopped and a message appears in the display on the washing ma-
chine. At the end of the peak-load function the programme resumes
automatically.
The serial interface RS-232 can be retrofitted to the washing machine
via an XKM RS 232 (optional accessory available from Miele). This
communication module must only be used with Miele Profes-
sional machines that are fitted with an appropriate slot for the module.
en - Installation notes
31