voestalpine Bohler Welding URANOS NX 2200 SMC Classic Mode D'emploi page 31

All the alarms and all the guard limits relating to the system are listed below.
Overtemperature
E01
Overcurrent
E05
Blocked motor
E08
Communication error WF1
E12.1
Invalid program
the error sub-code indicates the number
E14.xx
of the deleted job
Communication error RI
1000/2000/3000 (CAN bus)
E16.1
Communication error RI 1000/2000
E16.3
System configuration error
E19.1
Memory fault
E20
Welding programs not present
E23
Data loss
E32
Communication error (ACTIVATION KEY)
E33.3
Coolant shortage
E43
Emergency switch (Automation and
robotics)
E49
robotics)
E51
External flow switch fault (Automation
and robotics)
E53
Current level exceeded (Upper limit)
E55
Overtemperature
E02
Wire feeder motor power supply fault
E07
Power module overcurrent (Inverter)
E10
Communication error (FP)
E13
Invalid program
E15
Communication error RI 3000 (Modbus)
E16.2
Invalid program
the error sub-code indicates the number
E18.xx
of the deleted job
System configuration error (WF)
E19.11
Data loss
E21
Memory fault (RTC)
E27
System configuration error (LCD 3.5")
E33.1
System power supply fault
E40
Gas shortage
E44
Wire stuck (Automation and robotics)
E50
Anti-collision (Automation and robotics)
E52
Current level exceeded (Lower limit)
E54
Voltage level exceeded (Lower limit)
E56
31
ALARM CODES
EN