voestalpine Bohler Welding URANOS NX 2200 SMC Classic Mode D'emploi page 24

SETUP
Welding speed
399
Lets you set welding speed.
EN
Default cm/min: reference speed for manual welding.
Syn: Sinergic value.
Minimum
2 cm/min
500
Allows the selection of the required graphic interface.
Allows access to the higher set-up levels.
Refer to section "Interface personalisation (Set up 500)"
Value
USER
SERV
vaBW
551 Lock/unlock
Allows the locking of the panel controls and the insertion of a protection code.
Refer to section "Lock/unlock (Set up 551)".
Regulation step
601
Allows the regulation of a parameter with a step that can be personalised by the operator.
Minimum
1
602
603
705 Circuit resistance calibration
Allows the calibration of the system.
Refer to section "Circuit resistance calibration (set up 705)".
751 Current reading
Allow the real value of the welding current to be displayed.
752 Voltage reading
Allows the real value of the welding voltage to be displayed.
768 HI heat input measurement
Allows reading of the value of the measurement of the heat input in welding.
851 ARC-AIR enabling
Enable the ARC-AIR function.
Value
on
off
TIG DC LIFT START enabling
852
Enable or disable the function.
Value
on
off
5.1.2 List of set up parameters (MIG/MAG)
Save and Exit
0
Allows you to save the changes and exit the set up.
Maximum Default
200 cm/min 15 cm/min
Selected level
User
Service
vaBW
Maximum Default
Imax 1
Default ARC-AIR
- ACTIVE
X INACTIVE
Default TIG DC LIFT START
- ACTIVE
X INACTIVE
Value User interface
XE Easy Mode
XA Advanced Mode
XM Medium mode
XP Professional Mode
24
S Smart