INSTALLATION
1.8 IP Protection rating
IP23S
EN
IP
• Enclosure protected against access to dangerous parts by fingers and against ingress of solid bodies objects with
diameter equal or greater than 12.5 mm.
• Enclosure protected against rain at an angle of 60°.
• Enclosure protected against harmful effects due to the ingress of water when the moving parts of the equipment
are not operating.
1.9 Disposal
Do not dispose of electrical equipment together with normal waste!
In conformity to European Directive 2012/19/EU on Waste Electrical and Electronic Equipment and its
implementation according to national law, electrical equipment must be collected separately and disposed of
through an authorised recovery and disposal centre at the end of its life cycle. The owner of the equipment is
required to identify authorised collection centres on the basis of the information provided by Local Authorities. By
applying this European Directive you will improve the environment and human health!
» For further information, refer to the website.
2. INSTALLATION
Installation should be performed only by expert personnel authorised by the manufacturer.
During installation, ensure that the power source is disconnected from the mains.
The multiple connection of power sources (series or parallel) is prohibited.
2.1 Lifting, transport & unloading
• The equipment is provided with a handle for hand transportation.
•
•
Do not underestimate the weight of the equipment: see technical specifications.
Do not move or position the suspended load above persons or things.
Do not drop or apply undue pressure on the equipment.
2.2 Positioning of the equipment
Keep to the following rules:
• Provide easy access to the equipment controls and connections.
• Do not position the equipment in very small spaces.
• Do not place the equipment on surfaces with inclination exceeding 10° from to the horizontal plane.
• Position the equipment in a dry, clean and suitably ventilated place.
• Protect the equipment against pouring rain and sun.
skip
12