voestalpine Bohler Welding URANOS NX 2200 SMC Classic Mode D'emploi page 26

SETUP
Post-gas
16
EN
Minimum
0/off
24
Bilevel (4T - crater filler)
Permits adjustment of the secondary wire speed in the bilevel welding mode.
Minimum
1 %
30 Spot welding
Allows you to enable the "spot welding" process and establish the welding time.
Minimum
0.1 s
Pause point
31
Allows you to enable the "pause point" process and establish the pause time between one welding operation and
another.
Minimum
0.1 s
32
Secondary voltage (MIG Bilevel)
Allows regulation of the secondary pulsation level voltage.
Makes it possible to obtain greater arc stability during the various pulsation phases.
Minimum
-5.0
33
Secondary inductance (MIG Bilevel)
Allows regulation of the secondary pulsation level inductance.
Makes it possible to obtain a quicker or slower arc to compensate for the welder's movements and for the natural
welding instability.
Minimum
-30
Inductance
202
Allows electronic regulation of the series inductance of the welding circuit.
Makes it possible to obtain a quicker or slower arc to compensate for the welder's movements and for the natural
welding instability.
Minimum
-30
207
Synergy enabling (G3/4 Si1 - 100% CO2)
Value
on
off
331
Compensated average voltage
Lets you set welding voltage.
Maximum Default
99.9 s 2.0 s
Smart
" is used again, and so on.
Maximum Default
200 % 0/off
Maximum Default
99.9 s 0/off
Maximum Default
99.9 s 0/off
Smart
Maximum Default
+5.0 0/syn
Maximum Default
+30 0/syn
Maximum Default
+30 0/syn
Default Callback function
- (G3/4 Si1 - 100% CO ) Synergy disabled
X (G3/4 Si1 - 100% CO ) Synergy enabled (instead of G3/4 Si1 - Ar18% CO )
Smart
" can be used.
Smart
Smart
26