voestalpine Bohler Welding URANOS NX 2200 SMC Classic Mode D'emploi page 27

Displacement speed reference constant
398
Reference constant for all welding processes
Value of the movement speed of the torch to which the system refers to perform the calculations of the welding
parameters
Welding speed
399
Lets you set welding speed.
Default cm/min: reference speed for manual welding.
Syn: Sinergic value.
Minimum
syn min
500
Allows the selection of the required graphic interface.
Allows access to the higher set-up levels.
Refer to section "Interface personalisation (Set up 500)"
Value
USER
SERV
vaBW
551 Lock/unlock
Allows the locking of the panel controls and the insertion of a protection code.
Refer to section "Lock/unlock (Set up 551)".
Regulation step
601
Allows the regulation of a parameter with a step that can be personalised by the operator.
Minimum
1
602
603
604
605
607
608
653 Wire speed
It allow wire speed regulation (during wire loading phase).
Minimum
0.5 m/min
Circuit resistance calibration
705
Allows the calibration of the system.
Refer to section "Circuit resistance calibration (set up 705)".
751 Current reading
Allow the real value of the welding current to be displayed.
752 Voltage reading
Allows the real value of the welding voltage to be displayed.
Maximum Default
syn max 35 cm/min
Selected level
User
Service
vaBW
Maximum Default
Imax 1
Maximum Default
22.0 m/min 3.0 m/min
Value User interface
XE Easy Mode
XA Advanced Mode
XM Medium mode
XP Professional Mode
27
SETUP
EN
S Smart