voestalpine Bohler Welding URANOS NX 2200 SMC Classic Mode D'emploi page 28

SETUP
Wire speed reading
757
Allow the value of the motor encoder 1 to be displayed.
EN
Robot movement speed
758
Allows the arm movement speed of a robot or an automation device to be displayed.
Current reading (motor 1)
760
Allow the real value of the current to be displayed (motor 1).
HI heat input measurement
768
Allows reading of the value of the measurement of the heat input in welding.
770
Deposition rate measurement
Displays deposition rate measurement.
5.2 Specific procedures parameters
5.2.1 Interface personalisation (Set up 500)
Allows the parameters to be customized on the main menu.
500
A A llows the selection of the required graphic interface.
Value
XE
XA
XM
XP
Classic Equipment
XE mode
Not used
XA mode
Manual welding method.
XP mode
Smart Equipment
XE mode
It allows manual MIG welding with the adjustment of the motor slope.
XM Mode
XA mode
It allows manual MIG and synergic MIG welding.
XP mode
It allows manual MIG and synergic MIG welding.
Synergic control stays active during the different welding stages.
The welding parameters are constantly monitored and, if necessary, corrected according to precise analysis of the electric arc!
The synergic value can be corrected as a percentage according to the welder's requirements.
Smart
User interface
Easy Mode
Advanced Mode
Medium mode
Professional Mode
Smart S
28