Publicité
EN
INSTALLATION OF THE BRAKES
NOTE : Votre vélo en version disque est prévu au standard de fixation FLAT MOUNT compatible 160mm
avant et arrière. L'épaisseur de la base au niveau des fixations de l'étrier arrière est de 25mm.
1 - Hose connected to the caliper: Pass the rear
brake hose through the base and then the bottom
bracket, before running it through the diagonal tube
and into the headset.
2 - Remember to thread a foam sleeve (foam tube).
3 - NEVER spray any oily substances, oil,
hydrocarbons, or cleaning products on your discs
and pads. This poses a high risk of accidents.
Your E-765 is equipped with mounts for two bottle
cages, one on the seat tube and one on the diagonal
tube.
For sizes XS and S, we recommend using side-
entry bottle cages to avoid stressing the cage or
damaging the top tube.
Remove the four M5 screws with a 4 mm Allen
wrench. Install the bottle cages (refer to the
corresponding product manual), then re-tighten the
WARNING : Use only the original bottle cage
!
screws provided.
4 - New pads require bedding in. While riding at
low speed, brake 40 to 50 times, alternately using
the right and then the left brake, starting with short
bursts and gradually increasing the intensity and
duration of braking.
HYDRATION
Follow the manufacturer's installation instructions.
Our fork dropouts adhere to the Look standard with
a tapered through axle to eliminate any axial and
radial play (tightening torque: 11 Nm).
The E-765 is designed to accommodate wheels with
a maximum tire size of 700x42C.
To ensure the proper functioning of the FAZUA
motor, make sure to install a compatible FAZUA
magnet on any pair of wheels used with your E-765.
The pair of wheels for your E-765 is equipped
with this by default, but you will need to equip any
additional wheel pairs accordingly.
Despite the utmost care taken during production, if
a defect should appear or a repair be necessary,
please get in touch with your authorized LOOK
retailer and bring both the defective product and
your purchase invoice, as well as a clear description
of the issue. Alternatively, contact our customer
service team at
Chez
LOOK,
importance à la qualité de nos fabrications.
Cependant, si vous constatez un défaut ou avez
besoin d'une réparation, nous vous invitons à vous
rendre chez votre revendeur agréé LOOK avec le
Fig.22
produit concerné et votre preuve d'achat. N'oubliez
pas de préciser le problème rencontré, et nous
veillerons à ce qu'il soit pris en charge rapidement.
INSTALLATION OF THE WHEELS
CUSTOMER SERVICE
info@lookcycle.com.
SERVICE APRÉS-VENTE
nous
accordons
une
grande
EN
Publicité
